The most common plastic spoon, knife and fork are made by PP, PS material, biodegradable cutlery, common use PLA material. Widely used in daily necessities, aviation. To produce them, need the cutlery moulds. The steps to make the mould, shortly as below:

1. First, we have to know customer's output, and then set the cavity of the mould according to the output. Figure out the product arrangement, normally we have round and rectangular layout.

2. Then consider whether to use a cold runner or a hot runner or a semi-hot runner. The full hot runner system is expensive but with less waste; the semi-hot runner is affordable, the scraps are relatively high; the cold runner is cheap but with a lot of scraps. All depends on the customer's budget.

3. The choice of steel materials, generally the cutlery mould manufacturing needs a high-speed operation, we must choose the steel which can ensure the mould can run at high speed. Our Mould factory will use H13, S136, 2344, HRC42-45, these steel can guarantee high speed running.

4. The processing of manufacturing spoon mould, fork mould, knife mould is rough milling, semi-finishing, high-speed milling (spoon mould), parting surface, high-speed engraving (fork mould), polishing, mould collision, then start the trial test.

5. Also, customers can choose to make the fork, knife and spoon in one mould to save the cost.

We make the cutlery moulds according to customer's requirements until customer satisfy with final samples. We take great pride in providing custom, innovative solutions that are designed to meet the needs of our clients while providing excellent customer service and support.

If any plastic mould project interested, please don't hesitate to contact us by mail or phone.